NAiS GV42C, Reference Manual

Page: 266 / 506

Chapter 5 Transfer
5-2
Screen Data Check
Data required for communication with PLC are set in the screen data file and the
data is reflected in communications after its transfer to the GV series. Go to
[System Setting] to make the settings.
Setting for Communications with PLC
PLC Type Setting
Select the type of the PLC to be connected. Following the selection, the [Comm.
Parameter] dialog is displayed.
Communication Parameter Setting
[Read Area] and [Write Area]
These options are necessary for the GV series to display the specified
screen or confirm the currently displayed screen. Each area is provided with
3 words as default. Check that the memory addresses for these areas are
not already in use.
[Baud Rate], [Signal Level], [Parity], [Stop Bit], etc.
Set these options in accordance with the corresponding PLC data.
Other Settings
Before data transfer to the GV series, check the following settings as well.
GV Series Setting
Make settings for memory expansion, backlight, touch switch type, etc.
Font Setting
Set the font type to be displayed on the GV series.
Modular Jack
Make settings for the use of the modular jack (MJ1/MJ2).
Printer Setting
Make settings for the printer (its model, etc.) connected to the GV series.
For more information on the three words each given to the read area and the write area,
see “Chapter 1 System Setting” in the Reference Manual (Function).
For more information on the communication parameters, see the GV42/52/62 Hardware
Manual.
For more information, see “Chapter 1 System Setting” in the Reference Manual (Function).
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com