NAiS GT10, Technical Manual

Page: 41 / 195

GT10/GT30 2.1 Installation
18
(2) Insert the fittings into the grooves provided in the GT10 main unit, and tighten
the screws to secure the GT10 main unit to the installation panel.
Enlarged view
Four fittings and four screws provided
with the unit
CAUTION
Screw tightening torque
The screw tightening torque should be 0.1 N m to 0.25 N m.
Applicable panel thickness
A panel with a thickness of 1.0 mm to 6.0 mm should be used.
Installation angle
If the installation angle is between 60 degrees and 0 degrees
(horizontal), the operating voltage should be set to 25V DC or lower.
Installation angle
Clearance when the GT10 is installed
When installing the GT10, if other parts are being installed to the
panel or cables are being wired to it, we recommend providing a
clearance of 30 mm to 50 mm/1.18 inch to 1.97 inch around the
GT10. This prevents cables from being damaged, and facilitates the
installation work. Also, make sure that the slits in the main unit are
never obstructed.