Nac Hi-Moiton II, Quick Manual

Page: 51 / 71

51

MIC GAIN CONTROL
MIC1 STEP
-60dB, -50dB, -40dB, -30dB, -20dB, -10dB, 0dB, +4dB
Setting of Gain for MIC1 at Camera rear panel.
MIC1 FINE
-100 - 100 STEP:1
Fine-tuning of Gain for MIC1 at Camera rear panel.
MIC2 STEP
-60dB, -50dB, -40dB, -30dB, -20dB, -10dB, 0dB, +4dB
Setting of Gain for MIC2 at Camera rear panel.
MIC2 FINE
-100 - 100 STEP:1
Fine-tuning of Gain for MIC2 at Camera rear panel.

H PHASE CONTROL
H PHASE
-100 - +100
Setting for Horizontal Phase of GENLOCK and this is available for HD-SDI
out from the rear of Camera Head when in Stand Alone Style.
H PHASE can be controlled from CCU Menu when CCU is connected.

LENS SELECT
LENS SERIAL I/F
ON, OFF
Setting for ON/OFF of Lens Serial Interface. Set it ON usually

SYSTEM
BATTERY
WARNING
BATT WARN VOLT 10.5 - 13.5V
Warning displays on VF/PM1/PM2 when the selected Input Voltage on DC IN
Connector recognizes lower voltage
BARS MODE
BARS MODE FULL, MULTI
Setting for Color Bar Signal
BARS ON ON, OFF
Setting for ON/OFF of Color Bar output
CPU SYSTEM
CONTROL
SEMI SELF MODE ON, OFF
Setting ON keeps the following parameters when OCP is disconnected.
Setting OFF turns all the parameters to defaults when OCP is disconnected.
ON/OFF of CAP, BARS, CAL, IRIS, AWB CH, GAMMA, FLARE, MATRIX,
MATRIX CH, BLACK PRESS/STRETCH, KNEE, WHITE CLIP, COLOR SAT,
COLOR CORR, DTL, SOFT DTL, STEP GAIN
Number of GAIN, GAMMA, BLACK GAMMA, FLARE, TOTAL KNEE, R/G/B
KNEE, WHT CLIP, DTL, HI-LIGHT DTL, SOFT DTL, SKIN DTL, MATRIX,
COLOR CORR, COLOR SAT, WHT SHADE, BLK SET, PED
SEMI REMOTE MODE ON, OFF
Setting for side switches “GAIN”,”AWB”,“OUTPUT” when in Stand Alone
style. When ON, side switches become valid, but no control from OCP.
When OFF, no control from camera head, but only from OCP is valid.