Nac Hi-Moiton II, Quick Manual

Page: 29 / 71

29
9.4 Recording
A Select one of Blocks you want to start recording with by pressing the numeric key.
B Press REC and PLAY
buttons at the same time to start recording, and you will see ●
blinks on the Block on Block Status Character on PM2 output.
The block status on the LCD indication section of the slow controller switches to R and “ @ ”
mark blinks.
C Press either REC or STOP button to stop recording. REC button functions on
whatever the Block that is being selected, but STOP button only functions on the
selected Block.
D When REC button is pressed, the Block Recording stops according to the Trigger Mode
Setting (Refer to the following setting), and starts a new Block Recording according to
Recording Mode Setting (Refer to Chapter 9.3 F).
How to change Trigger Mode Settings (Regularly, END is selected).
1 Press AE button.
2 Press
 
buttons to call a desired Trigger Mode as you see on the display of the Slow
Controller.
・
011 TRG/STRT Records after the Triggered point
・
012 TRG/CENT Records 50% before&after the Triggered Point
・
013 TRG/END Records before the Triggered point
・
014 TRG/CSTM Records before&after according to the desired Triggered point
3 When TRIG/CSTM is selected, value setting is displayed at left below of the LCD indication
section.
You can change the value setting by pressing
 
of the cross-shaped button.
A numerical value decreases by pressing

, a numerical value increases by pressing

.