MV Agusta Rivale 800, Workshop Manual

Page: 66 / 456

- 50 -
Maintenance
B
- using the specific tool, unhook the 2 springs ( 1 );
The substitution of the springs must be car-
ried out utilising the appropriate tool.
Before reattaching the springs, ensure that
the stand can swing freely (with no friction
or sticking).
- remove the hinge plate ( 2 );
1
2
- remove the nut ( 3 ) and free the stand from the plate
but pulling off the pin ( 4 );
Proceed in the opposite order for reassembly, following
the instructions below:
- move the stand pin ( 4 ) in support, with grease on the
first threads;
- leave the stand free to move;
- tighten the nut (
3 );
- once again make sure the stand is free to move.
Stand nut tightening torque: 25 N·m
3
4
25 N•m