![MV Agusta Rivale 800 Workshop Manual Download Page 173](http://html.mh-extra.com/html/mv-agusta/rivale-800/rivale-800_workshop-manual_1860725173.webp)
Air intake injection system
- 21 -
D
Eldor power unit fault codes (with TEXA diagnostic software)
IDN
Component/Function
[Fault
Takeover
Cause
Fault detection rules
ATI
[DTC Code]
Symptom]
11
43
48
47
77
10
Gear sensor diagnosis
P0915
[0915 hex]
Over
maximum
Threshold
[0001]
Short circuit to
Supply volta-
ge or Vehicle
supply
CONDITION FOR DETECTION: Rpm > THRPM-
GEARDIAG
DETECTION: It is recognized a fault if
VGearPos>VGEARPOSMAX for a time > TGEAR-
SHIFT
Mark: during a gear shift the gear sensor voltage
goes to Vcc. As a voltage equal to Vcc means
short circuit or open circuit it is necessary to use a
timer (TGEARSHIFT) to discriminate the normal
operation from the real fault
Ck, Er, Vr
Under
minimum
Threshold
[0010]
Open Circuit
or Short
Circuit to
Ground
CONDITION FOR DETECTION: Rpm > THRPM-
GEARDIAG
DETECTION: It is recognized a fault if
VGearPos<VGEARPOSMIN
Ck, Er, Vr
Throttle sensor consistency test
P1120
[1120 hex]
Plausibility
[1000]
Short circuit to
Supply voltage
or Vehicle sup-
ply / Open
Circuit or Short
Circuit to
Ground
CONDITION FOR DETECTION: Always
DETECTION: It is recognized a fault if
|VangThrottle1-VangThrottle2|> VANGTHRCOH
PO, Ck, Er, Vr
Gas sensor consistency test
P1222
[1222 hex]
Plausibility
[1000]
Short circuit to
Supply voltage
or Vehicle sup-
ply / Open
Circuit or Short
Circuit to
Ground
CONDITION FOR DETECTION: Always
DETECTION: It is recognized a fault if |VGasPos1-
VGasPos2|> THGASPOSCOH
PO, Ck, Er, Vr
Throttle control diagnosis
P1220
[1220 hex]
Plausibility
[1000]
Short circuit to
Supply voltage
or Vehicle sup-
ply / Open
Circuit or Short
Circuit to
Ground /
Mechanical
Problems
CONDITION FOR DETECTION: Always
DETECTION: It is recognized a fault if
AngIntErr>MAXANGINTERR where AngIntErr =
AngThrObj – AngThrottle AngThrObj is throttle tar-
get AngThrottle is actual throttle position
PO, Ck, Er, Vr
Gas idle Switch consistency Test
P1223
[1223 hex]
Plausibility
[1000]
Signal is not
plausible or
not coherent
CONDITION FOR DETECTION: Always
DETECTION: It is recognized a fault if
VGasIDLSw<THLOW1GASSWDIA;
THLOW2GASSWDIA<VGasIDLSw<THUP1GAS-
SWDIA; VGasIDLSw>THUP2GASSWDIA
PO, Ck, Er, Vr
ION acquisition diagnosis
(IonBufferV)
P1300
[1300 hex]
Over
maximum
Threshold
[0001]
Short circuit to
Supply volta-
ge or Vehicle
supply
CONDITION FOR DETECTION: If Rpm >0
DETECTION: It is recognized a fault if IonBufferV
> VIONMAX
Er, Vr
Under
minimum
Threshold
[0010]
Open Circuit
or Short
Circuit to
Ground
CONDITION FOR DETECTION: If Rpm >0
DETECTION: It is recognized a fault if IonBufferV
< VIONMIN
Er, Vr
IDN ATI: Diagnosis fault number - PO: Power On - Ck: Cranking - Er: Engine Run - Vr: Vehicle Run
Summary of Contents for Rivale 800
