MUTOH ValueJet VJ-1604, Maintenance Manual

Page: 236 / 422

5 Self-Diagnosis Mode VJ-1604 Maintenance Manual
Rev.-00 5-38
(The following shows a case for “Bi-D 240 - Setup” is selected.)
5.7.6 Side Margin Adjustment Menu
This menu is used to adjust the printing margins.
To adjust the margins, follow the steps below.
1. Set media as necessary.
2. After media is set, the plotter prints out band feed correction adjustment patterns and cuts the media in
the following modes.
• Black, 1 pass, Uni-D, 360 dpi
* If "check" is selected, black replaces magenta.
3. Check the printed side margin adjustment patterns for the measurement.
1: Side margin
2: Media feed direction
4. Enter each measured value as the parameter.
(Input range: 0.0 to 20.0 mm (0.1 mm increments))
[<] key
[<] key
[>] key
[>] key
Press [Setting/Value+] or [Setting/Value-] key
to change unit to pulse
ޓ
1 pulse = 1/2880 inch
Pulse range: -400
VQ
400
Back to Uni 㨺 D/Bi-D Top menu
1
2
TOP
After pressing [Enter]key
After printing
Press [Setting/value+] or [Setting/value-] key
to select initialize or check
Press [Cancel] key to go back to
̌
Adj. 7 SideMargin
̍
Menu
Side Margin: 0.1 㨙㨙 increments
Range: 0.0 - 20.0 mm