MUTOH ValueJet VJ-1604, Maintenance Manual

Page: 395 / 422

VJ-1604 Maintenance Manual 9 Troubleshooting
9-73 Rev.-00
2. Is PC IP address
appropriate?
Yes: Proceed to (3).
No: Adjust TCP/IP
properties from
[Properties] of [Local
Area Connection] in
[Network Connections]
setting of PC. PC and
printer must have the same
subnet address (i.e.
192.168.1.1/24 and
192.168.1.253). "7.3.3
Required
Environment"
p.7-8
3. Is any device of the
same IP address as PC
or printer connected to
hub?
Yes: Disconnect the
applicable device from
network.
No: Proceed to (4). -
4. Is printer started in
board manager mode
and only POWER
LED turned on?
Yes: Proceed to (5).
No: Start printer in board
manager mode. If LCD
displays nothing, engine
component may be
defective or firmware may
not be installed (including
power cutoff due to power
failure during installation
or other causes.) "7.3.3
Required
Environment"
p.7-8
5. Is printer IP address
appropriate? (Check
address according to
Section 6.3.)
Yes: Proceed to (6).
No: Engine board may by
defective "4.4.7
Replacing
MAIN Board"
p.4-49
6. Is LAN
communication
between PC and other
device available?
Yes: Connect PC with
other device with LAN
cable and check with
method such as ping
command.
No: PC or engine board
may by defective. "4.4.7
Replacing
MAIN Board"
p.4-49
Table 9-15 Problems in Using Dedicated Network Software (Continued)
No. Event/symptom Check item Action Reference