MUTOH Toucan Hybrid PJ-162-FE, User Manual

Page: 16 / 251

User’s Guide – Toucan Hybrid
16 AP-750, Rev. 1.1 –- 23/04/04
Do not use thinner, Benzene, alcohol or other active agents except for following parts. Doing so may
result in malfunction of the product.
•
Inside the maintenance cover
•
Print head surface
Be careful not to spill water inside the printer. Doing so may result in a short circuit.
Never open the covers fixed with screws. Doing so may result in electrical shock or a malfunction in the
printer.
When cleaning the print head, be careful of the following. Incorrect cleaning may result in clogging of the
nozzles.
•
Do not touch the print head surface with bare hands.
•
Clean the print head wiper every time when ink is adhered to it or soak it in jetwash.
Do not tilt the printer, place it against a wall, or turn it upside down. Doing so may cause ink to leak
inside the printer. Also, movement after transportation is not covered by the warranty.
Have four or more people unpack and transport the printer.
When lifting the printer out of the packing box, be sure to remove the vinyl cover first, then grab the
holding sides of the printer. Lifting the printer with the vinyl cover on may cause your hands to slip and
drop or damage the printer.
Ensure that the plug has been disconnected from the power socket when it is not used for a long time.
Earth wires must be connected to wires or terminals which fulfil the conditions below.
•
Earth terminals of power socket
•
Earth wires with copper morsel that is at least 650 mm under ground
When refilling ink or jetwash fluid, always wear the protective gloves supplied with the unit.
Be sure to close the lid of the main tank tightly. If the lid is not tightly closed or loose, it will cause a
defect when purging, loading or unloading the ink.
Always perform the following work with 2 people.
•
Placement of the roll media / rigid media
•
Setting of the roll media / rigid media
•
Setting of the winding unit
•
Moving of media tray
When performing a head cleaning:
•
Put on the gloves supplied with the printer on both hands.
•
Use the print head wiper or polynit wipes supplied with the printer to clean printhead.
Otherwise the nozzle may become clogged.
Immediately after printing in roll mode, the media guide and the platen is very hot. Perform work after
the media guide and the platen have cooled down.
When changing the ink filter, always perform the following:
•
Turn the unit OFF.
•
Unplug the electrical power cord
•
Remove all cables connected with the unit
•
If any of these are connected while replacing the filter, the unit may be damaged.
When changing the ink filter, always wear the gloves supplied with the unit on both hands.
When cleaning the waste fluid tray, always wear the protective gloves supplied with the unit.
When cleaning the print head surface, always wear the protective gloves supplied with the unit.