MUTOH Toucan Hybrid PJ-162-FE, User Manual

Page: 94 / 251

User’s Guide – Toucan Hybrid
94 AP-750, Rev. 1.1 –- 23/04/04
4.7.5 Setting winding unit
The setup for the winding unit is described below.
When using the winding unit, set up the winding unit according to the following procedure.
Notes :
When using the winding unit, always load the media before printing.
Step 1 :
Make sure the levers are up.
Step 2 :
Attach the media tube to the scroller for the winding unit
•
Refer to “Placement of the roll media”
Notes :
When using the winding unit, always use the media tube attached to the product.
Step 3 :
Hold the scroller so that the flange on the side of the positioning ring is on the right, and attach
both ends of the scroller to the winding unit.
Notes :
Set the scroller onto the printer correctly by referring to the figure below. If the
direction of the attachment is wrong, the media will not be wound correctly.
No. Name
1 Winding unit
2 Scroller
3 Positioning
ring
Step 4 :
Pull out the roll media from the feed slot, and fix into place with tape so that the leading edge is
parallel with the media tube.