MUTOH Toucan Hybrid PJ-162-FE, User Manual

Page: 205 / 251

User’s Guide – Toucan Hybrid
205 AP-750, Rev. 1.1 –- 23/04/04
5.7.2 Roll media cutting procedure.
The roll media cutting procedure is described.
Cut the roll media according to the following procedure.
Caution :
Immediately after printing, the media guide and the platen is very hot. Perform work
after the media guide and the platen has cooled off.
Step 1 : After printing, the roll media will automatically advance to the media cut position.
The following message is displayed on the operation panel.
* ManualCutPaper *
Cut Paper
And Press ENTER
Step 2 : Place a razor blade on the media cut groove on the platen, and cut the roll media.
Caution :
• When cutting the roll media, be careful of the following. Incorrect handling can result in
injury to the hands and fingers from the razor blade.
When holding the media, do not place fingers over the media cut groove.
Move the razor blade slowly along the media cut groove.
No. Name
1 Platen
2
Media cut groove
3 Razor blade
Step 3 : Press the [ENTER] key of the operation panel.
Step 4 : The unit enters the normal status
Ready to Print
Cancel LeverUp
Feed&Reel Purge
User1 43 m
Step 5 : Cutting of the roll media is ended.