90
91
Adjusting the child seat
The knot in the rubber band allows the seat angle of the backrest to be adjusted
somewhat in the position against the direction of travel. Be aware that once the knot
is very tight, it is very difficult to loosen.
Make sure to select the appropria-
te harness height on the backrest
for your child. To adjust the harness
height, turn the harness end piece on
the back of the seat and slide it for-
ward through the slotted hole. Then
select the desired height and push the
end piece through the slot again from
the front.
The rods from which the child seat is
suspended can be adjusted in width.
The end pieces can be turned out and
in when the lock ring is loosened. The
rods are adjusted from the factory so
that some pressure is needed on the
wings to insert the rods. This is import-
ant so that the rods are locked well
into the basket. So, do not adjust the
rods so that they are very loose in the
basket.
Insert both rods parallel and evenly into the profile angles on the
right and left. Always remove the rods from the profile angles in
parallel. If one end of the rod is initially inserted and removed on
one side, it can very easily tilt and the seat cannot be installed
properly.
If you insert or remove the rods from one side, a large leverage
force is created which can quickly cause you to damage, bend
or break the rods and the profile angles.
Due to the hanging system and the safety belts, the children
in the seat are very well protected from road impacts. Never-
theless, it is essential to drive carefully and with foresight when
transporting children in the muli and avoid strong road impacts
and abrupt braking.
Child seat and child transport in the muli
Summary of Contents for Muskel
