2.
Screw locknut (2) onto screw (1) up to the end of the thread.
3.
The long end of holder (3) must face downwards. Push holder (3) through the plate openings (6).
Note:
The holders (3) must lock the flywheel only, not the ring gear.
4.
Install screw (1) into the bore of holder (1) until the holder (1) is locked in position.
Note:
Tighten screw (1) alternately on both sides of the flywheel housing.
5.
Tighten screw (1) alternately to specified tightening torque.
Name
Size
Type
Lubricant
Value/Standard
Screw
M10
Tightening torque
(Engine oil)
30 Nm +3 Nm
6.
Fit locknut (2) of screw (1) on plate (6) and secure.
Removing the transport locking
device from driving end (KS)
1.
Release the locknut (2) on both sides of
the flywheel housing, remove screw (1) and
take off the two holders (3).
2.
Unscrew screws (4) and remove together
with washers (5) and plate (6).
3.
Store the removed parts of the transport
locking device together with this documen-
tation carefully for possible reuse.
M015695/03E 2013-03
| Safety | 9
TIM-ID: 0000035999 - 002
