Temposonics
®
R-Series
V
PROFINET IO RT & IRT
Operation Manual
I 15 I
Multi-position measurement
The minimum distance between the magnets is 75 mm (3 in.).
Fig. 19: Minimum distance for multi-position measurement
RP5 with U-magnets
≥ 75 (≥ 3)
RP5 with magnet sliders
≥ 75 (≥ 3)
RP5 with block magnets
≥ 75 (≥ 3)
RH5 with ring magnets/U-magnets
≥ 75 (≥ 3)
RH5 with block magnets
≥ 75 (≥ 3)
4.5 Alignment of the magnet with the option “Internal
linearization”
The internal linearization offers improved linearity of the sensor.
The option must be specified in the order code of the sensor.
The internal linearization is set for the sensor during production.
A sensor with internal linearization is delivered with the magnet with
which the sensor was calibrated during production. In order to achieve
the best possible result, MTS Sensors recommends to operate the
sensor with the supplied magnet.
For the internal linearization, the following magnets can be used:
• Ring magnet OD33 (part no. 253 620), only for RH5
• U-magnet OD33 (part no. 254 226)
• Ring magnet OD24.4 (part no. 253 621), only for RH5
• Magnet slider S (part no. 252 182), only for RP5
• Magnet slider N (part no. 252 183), only for RP5
• Magnet slider V (part no. 252 184), only for RP5
• Magnet slider G (part no. 253 421), only for RP5
The ring magnet and U-magnet will be marked for the internal
linearization. During the installation, the magnets have to be aligned
to the sensor electronic housing, see Fig. 20, Fig. 21 and Fig. 22.
For RH5 PROFINET sensors with ring magnet applies:
• Install the magnet until the marking on the magnet points to the
sensor electronics housing.
• The marking on the magnet points to the same direction as the
elongated status LED in the lid of the sensor electronics housing.
Fig. 20: Alignment of the ring magnet on the RH5 PROFINET with internal linearization
ar in
E on at d stat s E
Controlling design dimensions are in millimeters and measurements in ( ) are in inches
NOTICE
For multi-position measurement, use magnets of the same type
e.g. 2 × U-magnet (part no. 251 416-2).
Do not fall below the minimum distance between the magnets of
bPPLQIRUPXOWLSRVLWLRQPHDVXUHPHQW&RQWDFW0766HQVRUV
if you need a magnet distance < 75 mm (3 in.).
