Continuous Sampling
21
11. Press the Stop button at any time in the cycle to end the continuous sampling. The
test status will show as Idle.
6.1.1 Continuous Sampling – with Clean Alarm Levels – Alarm Mode 1
Figure 1
Continuous Test Settings
This operating mode is similar to the Basic Operation, but in this mode the PML²
will stop testing when the specified clean alarm level is achieved.
A status of
COMPLETED
is shown when the specified clean alarm level is achieved.
(For other Alarm Modes refer to page 27).
•
Follow the instructions on page 15 for inputting settings - select Continuous
Test Type.
•
Input Test Interval- input the time in minutes that is required between the end
of a test and the begining of a new test.
•
Cleanliness Target options:
Clean Alarm Level (ISO) - Input desired Clean Alarm Level in the code format
Number/ Number/ Number – any code number combination can be input, from
code 5 to 24, example 10/9/5.
Summary of Contents for PML2
Page 1: ...PML Analyser UserGuide 200 052 EN www mpfiltri co uk ...
Page 6: ...6 Introduction Figure 1 ...
Page 38: ...38 Warranty ...
Page 62: ...Appendix K 62 Fault Finding ...
