Moyer Diebel 201HT M4 Series, Installation & Operation Manual

Page: 52 / 120

Installation - 201LT
Pump Priming - Detergent, Rinse-aid and Sanitizer Dispensing Pumps
201LT Control Panel
120
100
80
60
40
20
0
140
160
180
200
210
220
40
60
100
80
1110
120
C
F
20
0
-20
NSF
1. Make sure the chemical containers are full and the correct pick-up tubes are in their
containers.
2. Turn the dishwasher power switch ON. The switch will illuminate and the dishwasher
will fill with water.
3. Refer to the illustration below and note the two momentary push buttons provided to
prime the detergent, sanitizer and rinse aid pumps.
4. Open the dishwasher door and observe the inlet chute on the rear right-hand side of
the wash tank.
5. Push and hold the PRIME push button UP to the DETERGENT position until detergent
is observed entering the wash tank compartment. Release the push button.
6. Push and hold the same push button DOWN until sanitizer is observed entering the
wash tank compartment. Release the push button.
7. Push and hold the other push button UP to the RINSE AID position until air bubble
are observed moving in the pick-up tube, then hold the button for another 2 minutes
Release the push button.
8. Priming is complete.
Prime
Push button
44