Moyer Diebel 201HT M4 Series, Installation & Operation Manual

Page: 32 / 120

Operation - 201HT
Operation - 201HT
201HT Control Panel
1. Close the dishwasher front door.
2. Push the dishwasher Power Switch UP to turn the power ON.
3. The power switch will illuminate and the machine will fill with water.
4. Wait until the wash temperature gauge indicates a minimum of 150ºF/66ºC.
PLACE AN EMPTY DISHRACK IN THE MACHINE AND RUN THE FIRST
CYCLE EMPTY TO HEAT THE WASH TANK INTERIOR.
5. Load the dish rack into the machine. Wash one dish rack at a time.
6. Close the door, then press the START BUTTON for 1 second. The green in-cycle
light will illuminate and the wash cycle will begin. The total cycle is approximately
141 seconds.
7. Opening the door during a cycle will stop the dishwasher. If the door is open more than 5
seconds the cycle will restart from the beginning, if open less than 5 seconds the cycle
will resume where it left off when the dishwasher door is closed.
8. The final rinse cycle begins at the end of the wash cycle. The machine drains and then
refills with fresh water hot water. Check the rinse temperature gauge during the final rinse.
It must indicate a minimum of 180-195ºF/82-91ºC. The final rinse water is retained
for the next wash cycle.
9. When the green cycle light goes out, open the door and remove the rack of clean wares.
Normal Wash Mode
! ATTENTION !
DOOR LEFT OPEN DURING WASH CYCLE
If the dishwasher door is left open for more than 5 seconds during the normal wash mode, then
the dishwasher cycle will reset to the beginning of the normal wash cycle.
! ATTENTION !
RINSE SENTRY MODE WILL EXTEND WASH CYCLE TIME
In the event that the final rinse temperature has not reached 180-195ºF/82-91ºC after the
wash cycle, the rinse sentry will extend the wash cycle time until the booster reaches
180-195ºF/82-91ºC. If the proper temperature is not reached within 5 minutes, the machine
will leave the rinse sentry mode and complete the cycle.
Wash Temperature
Digital Display
Final Rinse Temperature
Digital Display
Prime
Push button
In-cycle Light Start
Push button
ON-OFF/DRAIN
Power Switch
Scrub
Delime
Pushbutton
24