Moyer Diebel 201HT M4 Series, Installation & Operation Manual

Page: 18 / 120

Installation - 201HT
Refer to the photo below:
3. Provide a 3 foot/1 meter service loop in the power supply cable to service the machine
4. Route the power cable from the rear of the machine to the terminal block making sure
the cable does not touch the booster tank.
5. Connect the power cable to the terminal block bracket using a suitable strain relief
connector.
6. Connect the power wires according to the wiring diagrams on page 3 for either
single phase or three phase operation.
7. Swing the chemical pump bracket and the chemical board back into position and
secure with the existing fasteners.
Connecting Incoming Power to the Main Terminal Block
for 1PH and 3PH Machines with Boosters
Main Terminal Block Cover Main Terminal Block
(continued from previous page)
10