Moyer Diebel 201HT M4 Series, Installation & Operation Manual

Page: 27 / 120

201HT - Installation
Detergent and Rinse-aid Pumps and Injection Points - 201HT
201HT Control Panel
1. The chemical dispensing pump supply lines must be primed before they will pump the
chemicals properly.
2. Make sure the chemical containers are full and the correct pick-up tubes are in their
containers.
3. Turn the dishwasher power switch ON. The switch will illuminate and the dishwasher
will fill with water.
4. Open the dishwasher door, then push
and hold the prime push button UP to the
DETERGENT position until detergent is
observed entering the wash tank compartment
through the fitting located on the back right
corner of the tank. Release the push button.
5. Push and hold the prime push button DOWN
to the Rinse-aid position until you see air
bubbles moving through the rinse-aid tubing
coming out of the chemical container. Release
the push button.
6. Close the door to complete the priming operation.
PRIME
DETERGENT
RINSE AID
! VERY IMPORTANT !
The chemical dispensing pumps must be primed before operating the dishwasher and
whenever the chemical container is changed.
Priming the Dispensing Pumps
(continued on next page)
19