Motorola Motorola PTP 250, User Manual, Page: 216 / 236

Restoring, resetting and rebooting Chapter 7 Operation
phn-2182_002v000
7-24
May 2011
Restoring, resetting and rebooting
This section describes how to restore the system configuration, reset to defaults,
recover the IP address and reboot the unit.
This section contains the following procedures:
x
Saving and restoring the configuration file on page 7-24
x
Resetting to default configuration (without country reset) on page 7-25
x
Resetting to default configuration (with country reset) on page 7-26
x
Recovering a lost IP address on page 7-28
x
Rebooting the unit on page 7-28
Saving and restoring the configuration file
Save the configuration (by following the procedure in Saving the system configuration
on page 6-11 ) in the following situations:
x
Before and after upgrading the firmware version.
x
Before replacing a faulty unit in the field.
x
After the unit has been configured or reconfigured.
The restore is only guaranteed to work if the installed firmware version has not been
changed since the configuration file was saved.
To restore the configuration file, proceed as follows:
1
Select menu option Configuration , Save And Restore . The Save & Restore
Configuration page is displayed ( Figure 6-11 ).
2 Select Browse and navigate to the PC folder containing the saved
configuration file (.cfg). Select Open .
4 Select OK to confirm the restore. The configuration file is uploaded and used
to reconfigure the unit to its previous state.