DSR-6100
39
Video Out Menu
Press the
buttons until the VIDEO OUT menu appears. Use this menu to modify the
video output format. When the input to the uplink encoder is 525-line, the field here selects
the unit output, either NTSC or PAL-M.
525 Field
Default: NTSC
Press the
4
button until the cursor is at the 525 label, and press the ENTER button
to move into the field. This field allows selection of the output format for 525-line
video as either NTSC or PAL-M. Use the
buttons to specify the desired option
and press the ENTER button to confirm the selection. Pressing the ENTER button
causes the following caution message to appear.
Press any arrow button (
4
) to back out of the field and leave it unchanged,
or press the ENTER button to proceed.
Firmware Menu
Press the
buttons until the Firmware menu appears. This menu displays the
DSR-6100's firmware release information, which is equivalent to the product
version number. This menu cannot be changed, but since the firmware is
periodically updated, this menu confirms that the update was successful. This menu
is used most commonly in troubleshooting. The High version value (shown below)
is the current firmware version.
Boot:FPGA:High Field
This field displays the version of boot, FPGA, and the high code. The boot code is
loaded at the factory. The FPGA and high codes may be upgraded to later versions
by a download that is delivered over the satellite signal from either the L-band or
ASI input. The code versions are represented by a six-digit hexadecimal number.
This field is non-editable.
VIDEO OUT
525
E NTSC
Press E to continue or to stop
CAUTION: Change will interrupt service
FIRMWARE Boot:FPGA:High Upgrade
E XXXXXX:XXXXXX:XXXXX 000000
