DSR-6100
29
Sat Field
Default: ---
If the Mode field is set to Manual, use this field to select a satellite name for the
designated port. This field is not editable when the Mode field is set to Auto.
Press the
4
button until the cursor is at the Sat label. Press the ENTER button to
move into the field. Use the
4
buttons to select the character position to be
changed. Then use the
buttons to scroll through the character choices and
press the ENTER button to confirm selection and exit the field.
This field displays dashes (---) when the port is not related to a satellite.
Polar Field
Default: ---
If the Mode field is set to Manual, use this field to select a polarity for the designated
port. Press the
4
button until the cursor is at the Polar label. Press the ENTER button
to move into the field and press the
buttons to display the options: H/LHP
(Horizontal/Left-Hand Polarity) or V/RHP (Vertical/Right-Hand Polarity). Select a
polarity and press ENTER button to confirm the selection and exit the field.
Port Config Menu
Use this menu to configure Low Noise Block (LNB) power for RF In Port 1. This
menus is not available when Input field is set to either ASI In or GigE In
Port
1 Power Field
Default: OFF
Use this field to direct power to the external Low Noise Block (LNB). Press the
4
button until the cursor is at the Port 1 Power label, and press the ENTER button to
move into the field. Press the
buttons to display the options: OFF and ON.
When the ON option is selected, the DSR-DSR-6100 supplies 16-22 VDC on the
RF In Port 1 antenna input connector, as shown in Figure 2-2 on page 10.
E Off
PORT CONFIG
Port 1 Power
