2
12
Connecting the DSR-6100
To connect a DSR-6100 to the GigE signal, see "GigE Usage" on page 23.
To connect a DSR-6100 to an ASI signal, "ASI Usage" on page 23.
To connect a DSR-6100 to an RF signal:
1.
Determine which satellite, transponder, Virtual Channel Table (VCT) number, and
Virtual Channel is to be used. Contact the programmer for this system information so
that the desired services can be received.
2.
Connect the desired L-Band (satellite antenna LNB or LNB signal splitter) source cable
to RF Input Port 1 through 8, as directed by the programmer.
3.
To view video and On-Screen Diagnostics (OSD) during installation, connect the OSD
Video Output on the DSR-6100 to a 75-ohm video monitor or television with
composite video input (standard definition).
Note: The DSR-6100 generates time-specific ad insertion cue tones. The programmer
can include these messages in the encoded signal.
4.
If cue tones are needed and made available, connect the differential Cue Tone+, Cue Tone-,
and Ground terminals on the DSR-6100 to the 600-ohm device receiving the tones.
Note: The DSR-6100 provides an alarm relay that can be used to signal an alarm
condition. To indicate an alarm, the DSR-6100 provides a short-circuit electrical
connection between the NC and CM terminals and an open-circuit electrical connection
between the NO and CM terminals. With this configuration, the DSR-6100 is able to
signal an alarm, even for the loss of AC power.
5.
Plug the DSR-6100 into a power source. Verify that the LCD screen is lit.
6.
Proceed with the installation using the front panel menus.
7.
For details on web server GUI, see "Remote Operation" on page 13.
