AGITO
31 - Setting up
AGITO User Manual OS 5.0 Nova
»
INSERTING DRIVE-ENDS
🌐
https://motion-impossible.com/how-to-videos/
Make sure the fixing bolts are removed then insert the drive end into
the chassis. You may need to push firmly for it to slot in.
Screw in tight the two fixing bolts on either side, be careful not to cross-thread. Where applicable
insert the steering pin by pressing down the blue button and fitting through the holes.
WHEN INSERTING THE DRIVE-END, TAKE CARE OF THE STEERING MECHANISM.
ENSURE THE STEERING PIN IS SECURELY LOCKED IN PLACE BEFORE OPERATION.
»
SETTING UP DRIVE-ENDS
Each Drive-end has its own specific characteristics and set-up process, this section is intended as an installation guide. Please see later
sections of this manual for full configuration, calibration and operational details.
»
SPORTS DRIVE-END: ATTACHING WHEELS
🌐
https://motion-impossible.com/how-to-videos/
Remove the Wheel nut from the shaft
Slide the wheel onto the shaft
Align the hexagons on the wheel and the shaft and slide in
Using the supplied AGITO Wheel Nut Tool to screw on the wheel nut.
Make sure it is tight (but take care not to damage the thread or
nut) to prevent it coming loose whilst in motion.
ALWAYS ENSURE WHEEL NUTS ARE SECURE, CHECK REGULARLY.
