Motion Impossible AGITO, User Manual

Page: 29 / 85

AGITO
AGITO User Manual OS 5.0 Nova 24 - Operating System www.Motion-Impossible.com
» TRAX MODE
»
CONNECT / CALIBRATION SCREEN (TRAX MODE)
The purpose of this screen is to ensure that the AGITO system is correctly configured for Trax Mode operation. The system status window
(centre of display) will display battery telemetry and confirm serial number of the core you are connecting to. It will also confirm the
application mode, i.e. Trax.
The system will then confirm system identification, Configuration and Calibration. If one of these steps requires action, e.g. Track Calibration,
then the user will be prompted to perform this process. Once each step has been completed, the screen will display “Done” and move an
to the next step.
See section “Trax Mode: Start up Connection & Calibration” on page 43
If a core is not connected, the system will time-out and enter the Trax Mode application.
The display will also show RF signal strength, RX / TX status as well as confirmation of attached modules: Core (Co), Tower (To), Hub-Box
(Hb). When a module is attached the relevant initials will turn from grey to green.
» HOME SCREEN (TRAX MODE)
When calibrated, the screen will switch to the application Home Screen. This screen is the normal operating status display for the AGITO
system, it is divided in to three distinct zones to help the operator quickly navigate information when in use, this screen will also display
system warnings.
RF Signal Strength
Data TX / RX status
Connected Module Status:
Core (Co) Tower (To) Hub-Box (Hb)
System Status window:
User Profile
Motor Mode & Throttle Mode
Mode Status window:
Tower Speed
Tower Acc & Dec Ramp limits
Mode Status window:
Tower Position
Tower limits
Mode Status window:
Motor Speed feedback & Speed limit
Acceleration limit
Mode Status window:
Track Position feedback
Deceleration limit
System Status window:
Battery Voltage feedback
MAG-Stop Status
Track Position Bar
Tower Position Bar