5.
COMMISSIONING USING THE GUI
The system is commissioned via the Dx2020 GUI operator interface.
For a detailed description of menus and procedures, please refer to the “Help” guide on the GUI itself.
5.1. Safety
WARNING
The drive may generate voltages up to 900 V, which are potentially lethal
Make sure all live parts are protected from contact with the human body
AVERTISSEMENT
L'entraînement peut générer des tensions jusqu'à 900 V, qui sont potentiellement létale Assurez que toutes les
parties électrifiées soient protégés de tout contact avec le corps humain
CAUTION
Changes to parameters without previous checks may cause unexpected and incorrect machine movement
CAUTION
Only qualified personnel are authorised to configure the parameters of a drive in operation
CAUTION
Before making the drive operative, it is advisable to make sure all parameters are configured correctly
ATTENTION
Les changements de paramètres sans contrôles précédents peuvent provoquer un mouvement inattendu et incorrecte de
la machine
ATTENTION
Seul le personnel qualifié est autorisé à configurer les paramètres d'un entraînement en fonctionnement
ATTENTION
Avant de procéder à l'opérateur d'entraînement, il est conseillé de vous assurer que tous les paramètres sont configurés
correctement
WARNING
When the drives are live, do not loosen the electrical connections. After removing the power supply voltage, capacitors
may still have dangerous voltages up to
6
minutes after switching off the mains. To ensure that conditions are safe,
measure the voltage on the intermediate direct-current circuit and wait until it has dropped below 40 V
WARNING
During operation, the heat sink and rear panel may reach very high temperatures of up to 80 °C and are therefore a
hazard for the operator's safety. Before operating, make sure the heat sink temperature is below 40 °C
WARNING
Before installation, the machine manufacturer must carry out an accurate risk assessment and take all measures
necessary so that unforeseen movement of the machine does not harm persons or damage property
MAR2-E-191
45
