REMOTE CONTROL KEYCHAIN
LOCK
Press once to arm doors and windows (only active if you have installed door/window sensors).
LOCK
Press twice to arm doors/windows and motion sensors.
UNLOCK
Press once to disarm the system.
Hold LOCK and UNLOCK
If you press both buttons for 3 seconds a panic signal is sent to the monitoring centre to notify an
emergency or panic call for help. The siren in the control panel will sound and the notification process will
start by contacting your nominated contacts in the order you specified, in addition a text message will be
sent simultaneously to all contacts you have selected to receive text messages. If the panic signal is
initiated from a Remote Control keychain this signal can only be disarmed by entering an access code on
the control panel (or with another Remote Control Keychain).
These functions are not available and will not activate the control panel.
TELEPHONE
This function enables you to communicate with your system remotely by dialling into your control panel using a
mobile phone or landline. This is particularly useful if you have forgotten to arm or disarm your system before
leaving home - or if you wish to hear the status of your alarm.
Note:
You may have to dial more than once to make contact with your system. If you get an engaged tone, wait 5
minutes and dial again.
•
Call your home telephone number that the panel is connected to and let the phone ring once then hang up.
•
Wait 10 - 40 seconds and call again.
•
The panel should answer on the first ring. The panel will announce
“System On”
.
•
Press the * button on your telephone and you will hear
“System Activated”
.
•
At this point you may perform the actions listed in the table below.
•
CODE refers to the master and access codes programmed into your system.
10
Panel Function
Phone Command
DISARM
* type CODE, type 1
ARM Doors/Windows (if installed)
* type CODE, type 2
ARM Doors/Windows with No Entry Delay (if installed)
* type CODE, type 2, type 2
ARM Motions
* type CODE, type 3
ARM Doors/Windows and Motions
* type CODE, type 2, type 3
System Status
* type CODE, type #, type 1
Hang Up
* type, CODE, type 9
35296 SSE User Guide 16/1/07 12:08 Page 10
