PROGRAMMING YOUR SYSTEM
Open the Panel Cover by pressing the plastic latch on the top of the panel. The label underneath provides
instructions designed to make system programming easier for you. Follow the prompts and flow arrows to complete
the desired task.
You will immediately be prompted by the panel voice to use the numbered keys to enter your ID, you must enter
your Master Access Code to unable programming.
Note:
The Master Access Code is 1234 when the panel is delivered to you. You should change your Master Access
Code after your system is installed to a number that you and your family will remember (see Access Codes section
on page 17).
•
SET THE CLOCK
If the panel loses power, the clock must be reset. The clock is set in 12 hour mode, giving you AM and PM options.
•
Open the panel cover. Panel announces,
Use numbered keys to enter ID.
•
Enter the Master Access Code. Panel announces,
Please select from Start Menu.
•
Press
Clock Set
from the Start Menu. Panel announces,
Time is ****, to change press hours and
minutes, then press done.
•
Follow the arrow from the
Clock Set
button to the
Hours
keys.
•
Press the
Hours
+/– keys and listen to the voice prompts. Stop when panel voice announces the
correct hour.
•
Press the
Minutes
+/– keys and listen to the voice prompts. Stop when the panel announces the
correct minutes.
•
Press
Done
. The panel will announce the set time.
•
Close the cover.
16
35296 SSE User Guide 16/1/07 12:08 Page 16
