3. Enter the System password.
4. Type in a new name for the proposed tool and press [
Ent
].
5. If the tool is connected via a network to any other cabinet, the next step
presents an option to choose the local controller (labelled “Serial Port”) or
a remote controller (labelled “hrcnetx”).
• If no network connected controllers are detected, then it automatically
skips this step and goes straight to step 6.
6. The console runs an automatic card detect routin
e to find out what type
and how many cards are fitted in the selected controller.
7. Once the routine is complete, the SetUp page opens and the controller
parameters can be configured for this tool.
NOTE
If the system has any problem running the detect sequence, it may report
“Auto Detect Failed” and ask if you want to repeat the Detect routine. If
the reason for failure is obvious, such as a loose network cable or a mains
glitch, then you may choose [
OK
] to retry card detection.
If the detection routine continues to fail, contact your supplier for advice.
5.4 Cards That May Be Detected
Table 5-1 Cards That May Be Detected
6-zone card at 15 Amp rating for probes and manifolds
Quad Input/Output card with programmable input and
output options
Create the First Tool - continued
5-3
SETUP
© 2021 Mold-Masters (2007) Limited. All Rights Reserved.
M1 Plus Controller User Manual
