7.3 Check Touchscreen Alignment
To reset touchscreen alignment, use the Calibration routine found on the
Utilities page. The Calibration routine places a crosshair target at five different
positions on the screen. A suitable stylus should be used to make a small
point of contact with the screen. The stylus should be held in position for a
couple of seconds to provide a good reading for calibration.
1. On the Utilities page choose [
Calibrate Touch
] and then choose [
Set
].
2. Choose [
Enable
] and choose [
OK
].
3. Touch the center point of the crosshairs.
• When you stop touching the screen, the crosshair target will move to
another position.
4.
Repeat until all five locations have been tested.
7-4
M1 Plus Controller User Manual
MAINTENANCE
© 2021 Mold-Masters (2007) Limited. All Rights Reserved.
