Mocom B Classic-28, Operating Instructions Manual, Page: 63 / 97

65
For better quality maintenance, supplement ordinary checks with regular periodic examinations
by the service department ( see Appendix ).
It is also fundamental to perform a periodic sterilizer validation , i.e., a check of the
thermodynamic parameters of the process, comparing them with the reference values provided
with suitably calibrated instruments. In this regard, see the paragraph, “Periodic Sterilizer’s
Validation”, further below in this Appendix.
The ordinary maintenance described below consists in easy manual operations and preventive
interventions involving simple instruments.
WARNING
IN THE EVENT OF THE REPLACEMENT OF THE DEVICE’S COMPONENTS
oR paRTS, RequeST and/oR uSe oRIGInal ReplaCemenT paRTS
only.
The table summarizes the maintenance required to keep the sterilizer operating at peak
efficiency. In the case of very intense use , we recommend shortening maintenance intervals:
DAILY
Clean the gasket on the porthole
Clean external surfaces
WEEKLY
Clean the sterilization chamber and relative accessories
Disinfect external surfaces
MONTHLY
Clean the internal (and external - if installed) distilled water
tank
Safety valve maintenance
Clean (or replace) the drain filter
ANNUALLY Validate sterilizer ( see dedicated paragraph )
The steriliser periodically reminds the user about necessary “routine” maintenance operations
that must be carried out in order to ensure the proper operation of the device.
press the
ok
button to confirm that the required maintenance operation has been completed.
press the button to postpone the operation.
In this case, the warning message will reappear the next time the sterilizer is used. .
INTRODUCTION
APPENDIX
–
MAINTENANCE
In addition to correct use, the user needs to perform ordinary maintenance in order to guarantee safe, efficient operation over the
device’s entire life.
ORDINARy
MAINTENANCE
PROGRAM
Scheduled Maintenance
Messages
Message
Clean the dust filter
Replace the bacteriological filter
OK