6
3. INTRUDER ALARM: OPERATION
3.1 SWITCHING ON AND OFF
To activate the Mobeye Argos movement detector, use the installation code or user code.
Enter your code
Press “OK”
The light turns red shortly and an indication tone is started. This repetitive tone will last during the exit delay of 60
seconds. As soon as the acoustic signal stops, the Mobeye Argos is active.
- If the code is entered incorrectly 3 times, the indicator turns red and the Mobeye Argos will be blocked for 10
minutes.
-
The action can be interrupted at any time, by twice pressing “OK”.
- The entry indication and siren are off as factory default. Look at the next chapter how to activate them.
To de-activate the Mobeye Argos movement detector with your code.
Enter your code
Press “OK”
The light switches to green and a confirmation melody is played.
The system needs to be switched on and off using the same code; the installation code and user code are not
interchangeable.
3.2 ALARM MESSAGE, CONFIRMATION AND LISTEN-IN
When the armed system detects a movement, it first waits for the entry delay period and then it alarms. During the
entry delay the GSM module starts to establish a connection to the network. If the system was not disarmed, the
alarm messages follow. First an SMS text message is sent to all programmed alarm numbers; next a phone call is
made to the numbers. When you answer the phone, a beep tone is heard.
Confirm using
“1”
It is possible to confirm the phone call by answering the phone and pressing
“1“. The other alarm numbers will not
be called afterwards.
Listen-in using
“9”
It is possible to start a listen-in connection by answering the phone call and pressing
“9”. You will then be able to
hear anything in the immediate vicinity of the Mobeye Argos. If
the siren was set to “loud”, it is stopped. After two
minutes one hears two short beeps; if one presses
“9” again, the listen-in is extended by another two minutes. By
pressing
“9” the call is confirmed as well and the other alarm numbers will not be called afterwards.
