10
5. TEMPERATURE ALARM
5.1 CONFIGURATION
To change the settings, please follow these instructions:
Enter your 4-digit code (factory se
tting is “1111”)
Press “menu” - light turns green
Enter the menu number (see list below)
Press “OK”
Enter the new setting
Press “OK”. The light switches off, a confirmation melody is played
In the event of an incorrect entry, the light turns red and a short beep sounds. The menu can be left from any
position, by twice pressing “OK”.
Following settings are possible:
Menu nr.
Description
Options
Factory setting
41
Minimum temperature limit
000-050
(0 to 50ºC)
110 -101
(-10 to -1ºC)
999 = off
999 (off)
42
Maximum temperature limit
000-050
(0 to 50ºC)
110-101
(-10 to -1ºC)
999 = off
999 (off)
49
Correction factor temperature
01-09
(+1 to +9ºC)
11-19
(-1 to -9ºC)
00
(no correction)
00
78
Delay temperature alarm
00..60 (min.)
1
84
Repeat time
0..99 (hours)
4
5.2 MONITORING THE TEMPERATURE LIMITS
The Mobeye Argos is able to send a temperature alarm as soon as the actual temperature reaches a programmed
min. or max. level. This function can be used independently of the motion detection. As soon as the temperature is
too high or too low, an SMS text message is sent, followed by a telephone call. As long as the out of range
temperature remains, the report will be repeated every four hours (factory default). Once the temperature is back to
normal, the Mobeye Argos confirms this to you.
This function is active as soon as a temperature limit is programmed. By resetting the limits, the function becomes
inactive.
5.3 ADJUSTING THE TEMPERATURE
The built-in temperature sensor may have a standard deviation of the actual temperature. In this case, the deviation
will be similar at all temperatures. It is possible to correct the temperature deviation in the Mobeye Argos. In the
SMS setting summary, you see the reported temperature. If a correction is specified, it is processed in the displayed
temperature; the correction factor itself is displayed separately.
Example: Mobeye temperature: 13 °C. Actual temperature: 14 °C. To correct this deviation, one degree should be
added.
5.4 DELAY TIME
The temperature delay time defines the duration a temperature limit is exceeded before an alarm is initiated. If the
temperature returns to the non-alarm status within the delay time, no alarm is sent. The delay time can be set
between 0 and 999 minutes.
As default, the temperature delay time is set to 0 minutes.
5.5 ALARM REPEAT
In order to emphasize the urgency of the alarm messages, the temperature alarm (and alarms on the inputs 1 and
2) can be repeated. As long as the alarm status has not returned to the inactive status, the SMS alarm will be
repe
ated after the ‘alarm repeat time’ (as long as the alarm SMS is “ON”). In the repeated temperature alarm
message the actual temperature is mentioned as well, to follow the temperature development. The time can be set
between 0 and 24 hours. As default the alarm repeat time is set to 4 hours.
