Mobeye argos i200, User Manual

Page: 6 / 27

5
2. TO GET READY IN FOUR STEPS
To get started with the Mobeye Argos only four steps are needed.
1. Place the SIM card in the Mobeye Argos.
Make sure this SIM card is not secured by a PIN code.
2. Insert the four batteries.
3. Enter at least one phone number in the Mobeye Argos.
4. Check the settings
In this chapter these steps are explained.
2.1 STEP 1: SIM CARD
To use the Mobeye Argos a SIM card from any network is needed. On this SIM card, the PIN
code security needs to be disabled or 0000. If you have a SIM card with PIN code, you can
disable or change this using any mobile phone and change the PIN code security. Please
consult the manual for that mobile phone for the procedure.
The SIM card needs to be inserted before the batteries. When using a prepaid SIM card, take
note of the available credit. Additionally it is wise to set a recurrent test message in the menu
so the card will be used at least once a month.

Open the back cover

Insert the SIM card in the holder. For opening/closing, move the cover slightly.
2.2 STEP 2: INSERTING THE BATTERIES
Insert the four lithium 3,0 volt batteries (CR123). When replacing the batteries, all settings remain unchanged.
After inserting the SIM card and the batteries, the Mobeye Argos will perform a self test taking 1 minute. During the
test, the light is red.
If the light is flashing red, a problem with the SIM card is detected. A reason could be no SIM card was placed, or
the PIN code security of the SIM card was not disabled.
Close the Mobeye Argos using the 4 screws.
2.3 STEP 3: PROGRAM THE PHONE NUMBERS
You need to program at least one phone number in the unit as alarm number.

Enter your 4 digit code (factory setting: “1111”)

Press “menu”

Enter “101”

Press “OK”

Enter the phone number (e.g. 0712345678 or 0044712345678)

Press “OK”
The light turns green and a confirmation melody is played.
The Mobeye Argos is ready to use.
2.4 STEP 4: CHECK THE SETTINGS
The settings can be sent to the programmed telephone number as SMS text message. In this way you also check
the correct working of the SIM card.

Enter your 4 digit code (factory setting: “1111”)

Press “menu”

Enter “10”

Press “OK”
Within ca. 30 seconds the programmed phone number will receive the list with settings.