MKN HansDampf 10.1, Service Manual

Page: 31 / 72

Service manual
Service menu HansDampf Silver
The service menu is for configuration and Problem analysis for electrical components. Not all
procedures have to be done. It has to be done completely when the control pcb is being replaced.
To enter the Service menu do the following:
1. Switch the unit on
2. Press Flexi Button and choose
with the upper knob
Par
(parameter)
3. Press Start/ Stop- Button and on
the lower displays shows
000
.
4. Enter Password
777
with the lower knob
5.
Press Start/ Stop- Button
S0F
(Software) is shown on the lower
display
Now in lower display the configuration steps are displayed in the
lower display, with the knob you can choose the wanted step
6. By pressing the Start/ Stop-
Button the step (test) is started
How to save changes:
If changes are to be saved the FLEXI Button has to be pressed when the procedures are displayed.
„Sto“ is shown in the Display (Store) to indicate that the changes have been saved. After saving the
main menu is presented.
Saving the parameters is very important otherwise changed values are not stored and the machine
might not be operable.
31
Par
000
777
S0F