Mitsubishi Fuso CANTER FE85DE6SLGP, Shop Manual

Page: 239 / 336

13E-52
2. Multi-Use Tester Service Data
• It is possible to see service data and actuator tests simultaneously.
No. Item Data Inspection condition Requirement
01 Engine Revolution Racing (engine running)
Value corresponds to ta-
chometer indication.
02 LOAD Value Starter switch in ON position 0 %
0A Reference Injection Quantity Starter switch in ON position 0 %
20 Atmospheric Pressure
Altitude: 0 m 101 kPa
Altitude: 600 m 95 kPa
21 Boost Pressure
Starter switch ON (engine stopped)
Agrees with atmospheric
pressure.
Accelerator pedal pressed after start of
engine
Gradually increases.
22
Difference pressure across
DPF
Idling 0 kPa
30 Intake Air Temp.
(upper stream)
On a cold engine
Equal to ambient tempera-
ture
31 Intake Air Temp. (downstream) On a cold engine
Equal to ambient tempera-
ture
32 Water Temperature
Engine cold
Value corresponds to
ambient temperature.
Engine in process of warming up Value gradually increases.
Engine stopped after warming up Value gradually decreases.
33 Fuel Temperature (inlet)
Engine cold
Value corresponds to
ambient temperature.
Engine in process of warming up Value gradually increases.
Engine stopped after warming up Value gradually decreases.
40 Accel Pedal Sensor Voltage 1
Accelerator pedal gradually pressed
from released position
0.85 to 4.15 V
41 Accel Pedal Sensor Voltage 2
Accelerator pedal gradually pressed
from released position
0.85 to 4.15 V
42 Accel Pedal Position
(unfiltered)
Accelerator pedal not pressed 0 %
Accelerator pedal gradually pressed Value gradually increases.
Accelerator pedal fully pressed 100 %
43 Accel Pedal Position
(filtered)
Accelerator pedal not pressed 0 %
Accelerator pedal gradually pressed Value gradually increases.
Accelerator pedal fully pressed 100 %
50 Target EGR Valve Position Idling 0%
51 Actual EGR Valve Position
Idling 0%
[Actuator test] A0: EGR 1
52 Target Intake Throttle Position Idling 90%
53 Actual Intake Throttle Position
Idling 90%
[Actuator test] A3: Intake Throttle 1
54 Target VGT Position Starter switch ON 10%
55 Actual VGT Position
Starter switch ON 10%
[Actuator test] A4: VGT 1, A5: EGR, ETV, VGT
60 Air mass flow Accelerator pedal is pressed gradually. Flow rate to be increased
accordingly
80 Power Supply Voltage Starter switch ON
Value matches battery
voltage.
81 Idle Volume Voltage SLOW to FAST 1 to 3 V
82
Q Adjustment Resistor No.
(Part name: Fuel injection rate
adjustment resistor)
1/2/3/4/5/6/7/8/9/10/
11/NON
–
Number matches number
marked on fuel injection
rate adjustment resistor.
90 Vehicle Speed Vehicle in motion
Value corresponds to
speedometer indication.
.rpm
. %
. %
. kPa
. kPa
. kPa
. ° C
.
°
C
.
°
C
.
°
C
. V
. V
. %
. %
. %
. %
. %
. %
. %
. %
. g/s
. V
. V
.km/h
TROUBLESHOOTING