Mitsubishi MOTORS ATTRAGE, Manual

Page: 209 / 222

Replacement of lamp bulbs
10-20 Maintenance
10
E01003201734
E01003305821
Codes in parentheses indicate bulb types.
 When it rains, or when the vehicle has been
washed, the inside of the lens sometimes
becomes foggy. This is the same phenome-
non as when window glass mists up on a
humid day, and does not indicate a functional
problem. When the lamp is switched on, the
heat will remove the fog. However, if water
gathers inside the lamp, please go to an
authorised MITSUBISHI MOTORS dealer
for a check.
Bulb location and capacity
CAUTION
 When replacing a bulb, be sure to use a new
bulb of the same type, wattage, and colour.
If you install a different bulb, the bulb could
malfunction or fail to come on and could
lead to a vehicle fire.
NOTE
Outside
Type A: Halogen headlamps type
Type B: LED headlamps type
1- Front turn-signal lamps: 21 W (PY21W)
2- Position lamps (Type A): 5 W (W5W)
Position lamps/Daytime running lamps
(Type B):
−
Front
Type A
Type B
3- Headlamps
Type A: 60/55 W (H4)
Type B: −
4- Front fog lamps * : 19 W (H16)
5- Side turn-signal lamps (on fender)*: 5 W
6- Side turn-signal lamps (on outside rear-
view mirror)*
NOTE

It is not possible to repair or replace only the
bulb for the side turn-signal lamp (on
fender).
For repair and replacement, contact an
authorised MITSUBISHI MOTORS dealer.
 The following lamps use an LED instead of
the bulb.
If you need to repair or replace these lamps,
contact a MITSUBISHI MOTORS Author-
ised Service Point.
• Headlamps (Type B)
• Position lamps/Daytime running lamps
(Type B)
• Side turn-signal lamps (on outside rear-
view mirror)