Mitsubishi MOTORS ATTRAGE, Manual

Page: 46 / 222

Rear seat
Seat and seat belts 4-3
4
E00400901551
To adjust the armrest angle, tip the armrest
forward and then raise it to the desired posi-
tion.
To release the armrest angle, raise it fully
rearward as shown.
E00401300018
E00401701820
To use the armrest, fold it down.
To return to the original position, push it
backward until it is flush with the seat.
E00403302667
CAUTION
 The reclining mechanism of the seatback is
spring loaded, causing it to return to the ver-
tical position when the lock lever is operated.
When using the lever, sit close to the seat-
back or hold it with your hand to control its
return motion.
Armrest (Driver’s seat only)
*
NOTE
 Do not stand or sit on the armrest. It could
break.
Rear seat
Armrest
NOTE
 The top surface of the armrest contains a cup
holder for rear seat occupants.
Refer to “Cup holder” on page 7-17.
Head restraints
WARNING
 Driving without the head restraints in
place can cause you and your passengers
serious injury or death in an accident. To
reduce the risk of injury in an accident,
always make sure the head restraints are
installed and properly positioned when
the seat is occupied.
 Never place a cushion or similar device on
the seatback. This can adversely affect
head restraint performance by increasing
the distance between your head and the
restraint.
 When a person sits in the rear seat, pull
up the head restraint to a height at which
it locks in position. Be sure to make this
adjustment before starting to drive. Seri-
ous injuries could otherwise be suffered in
the result of an impact.