Mitsubishi MOTORS ATTRAGE, Manual

Page: 68 / 222

Multi-information display
Instruments and controls 5-5
5
E00531200017
This displays the average fuel consumption
from the last reset to the present time.
The reset mode conditions for the average
fuel consumption display can be switched
between “Auto reset” and “Manual reset”.
For information on how to change the aver-
age fuel consumption display setting, refer to
“Changing the function settings” on page 5-8.
E00531101169
The accumulated time the engine has been
stopped by Auto Stop & Go (AS&G) system
is displayed.
Refer to “Auto Stop & Go (AS&G) system”
on page 6-19.
E00533501109
This displays the temperature outside the
vehicle.
E00533401108
If the outside air temperature drops below
approx. 3°C (37 °F), the alarm sounds and the
outside air temperature warning symbol (A)
flashes for about 10 seconds.
 When you refuel, the driving range display is
updated.
However, if you only add a small amount of
fuel, the correct value will not be displayed.
Fill with a full tank whenever possible.

On rare occasions, the value displayed for
the driving range may change if you are
parked on an extremely steep incline. This is
due to the movement of fuel in the tank and
does not indicate any malfunction.
 The display setting can be changed to the
preferred units (km or miles).
Refer to “Changing the function settings” on
page 5-8.
Average fuel consumption dis-
play
NOTE NOTE
 The average fuel consumption display can be
reset separately in both auto reset mode and
manual reset mode.
 “---” is displayed when the average fuel con-
sumption cannot be measured.
 The initial (default) setting is “Auto reset
mode”.
 The average fuel consumption will depend
on the driving conditions (road conditions,
how you drive, etc.). The displayed fuel con-
sumption may vary from the actual fuel con-
sumption. Treat the fuel consumption
displayed as just a rough guideline.
 The memory of the manual reset mode or
auto reset mode for the average fuel con-
sumption display is erased if the battery is
disconnected.

The display setting can be changed to the
preferred units {km/L, L/100 km, mpg}.
Refer to “Changing the function settings” on
page 5-8.
Auto Stop & Go (AS&G) moni-
tor
NOTE
 When the ignition switch or the operation
mode is ON again, the accumulated time will
be reset.
Outside temperature display
NOTE
 The display setting can be changed to the
preferred units (°C or °F).
Refer to “Changing the function settings” on
page 5-8.
 Depending on factors such as the driving
conditions, the displayed temperature may
vary from the actual outside temperature.
Frozen road warning