Mitsubishi MOTORS ATTRAGE, Manual

Page: 85 / 222

Rear window demister switch
5-22 Instruments and controls
5
Because the wipers will start operating
again after the wiper motor cools down,
check that the wipers operate before using
them.
 Do not use the wipers when the glass is
dry.
They may scratch the glass surface and
the blades wear out prematurely.
 Before using the wipers in cold weather,
check that the wiper blades are not frozen
onto the glass. The motor may burn out if
the wipers are used with the blades frozen
onto the glass.
 Avoid using the washer continuously for
more than 20 seconds. Do not operate the
washer when the fluid reservoir is empty.
Otherwise, the motor may burn out.
 Periodically check the level of washer
fluid in the reservoir and refill if required.
During cold weather, add a recommended
washer solution that will not freeze in the
washer reservoir. Failure to do so could
result in loss of washer function and frost
damage to the system components.
E00507902561
The rear window demister switch can be
operated when the engine is running.
Push the switch to turn on the rear window
demister. It will be turned off automatically in
about 20 minutes. To turn off the demister
within about 20 minutes, push the switch
again.
The indicator lamp (A) will illuminate while
the demister is on.
E00508000640
Press the steering wheel on or around the
“ ”mark.
Rear window demister
switch
Type 1
Type 2
NOTE
 The demister switch is not to melt snow but
to clear mist. Remove snow before use of the
demister switch.
 To avoid unnecessary discharge of the bat-
tery, do not use the rear window demister
during starting of the engine or when the
engine is not running. Turn the demister off
immediately after the window is clear.
 When cleaning the inside of the rear window,
use a soft cloth and wipe gently along the
heater wires, being careful not to damage the
wires.

Do not allow objects to touch the inside of
the rear window glass, damaged or broken
wires may result.
Horn switch