Mitsubishi MOTORS ATTRAGE, Manual

Page: 192 / 222

Catalytic converter
Maintenance 10-3
10
E01011501127
Only use the appointed position as shown in
the illustration.
E01000202440
The exhaust gas scavenging devices used
with catalytic converter are extremely effi-
cient for the reduction of noxious gases. The
catalytic converter is installed in the exhaust
system.
It is important to keep the engine properly
tuned to ensure proper catalyst operation and
prevent possible catalyst damage.
E01000304807
1. Pull the release lever toward you to
unlock the bonnet.
If your vehicle is raised with a
garage jack
*- Front of the vehicle
WARNING
 Set the jack only at the positions shown
here. If the jack is set at a wrong position,
it could damage your vehicle or the jack
might fall over and cause personal injury.
Never use the rear
suspensions as a
jacking point.
 Do not use the jack on a tilted or soft sur-
face.
Otherwise, the jack might slip and cause
personal injury. Always use the jack on a
flat, hard surface. Before setting the jack,
make sure there are no sand or pebbles
under the jack base.
Catalytic converter
WARNING
 As with any vehicle, do not park or oper-
ate this vehicle in areas where combustible
materials such as dry grass or leaves can
come in contact with a hot exhaust since a
fire could occur.
 Paint should not be applied to the catalytic
converter.
WARNING NOTE
 Use fuel of the type recommended in “Fuel
selection” on page 2-2.
Bonnet
To open