Mitsubishi MOTORS ATTRAGE, Manual

Page: 81 / 222

Combination headlamps and dipper switch
5-18 Instruments and controls
5
E00528902317
This function turns on the position and tail
lamps for about 30 seconds after the
UNLOCK switch on the remote control trans-
mitter is pressed when the combination head-
lamps and dipper switch is in the “OFF” or
“AUTO” position (for vehicles equipped with
the automatic lamp control). On vehicles
equipped with the automatic lamp control, the
welcome light function will operate only
when it is dark outside the vehicle.
E00529002009
This function turns on the headlamps in the
low beam setting for about 30 seconds after
the ignition switch is turned to the “LOCK”
position or the operation mode is put in OFF.
1. Turn the combination headlamps and dip-
per switch to the “OFF” or “AUTO” posi-
tion (for vehicles equipped with the
automatic lamp control).
2. Turn the ignition switch to the “LOCK”
position or put the operation mode in
OFF. Also, if a key was used to start the
engine, remove the key from the ignition
switch.
3. Within 60 seconds of turning the ignition
switch to the “LOCK” position or putting
the operation mode in OFF, pull the turn-
signal lever towards you.
4. The headlamps will come on in the low
beam setting for about 30 seconds. After
the headlamps go off, the headlamps can
be turned on again in the low beam setting
for about 30 seconds by pulling the turn-
signal lever towards you within 60 sec-
onds of turning the ignition switch to the
“LOCK” position or putting the operation
mode in OFF.
To turn on the headlamps again after
60 seconds of turning the ignition switch
to the “LOCK” position or putting the
operation mode in OFF, repeat the process
from step 1.
 If you turn the lamps off with the headlamps
set to high-beam, the headlamps are auto-
matically returned to their low-beam setting
when the lamp switch is next turned to the
“
” position.
Welcome light
NOTE

While the welcome light function is operat-
ing, perform one of the following operations
to cancel the function.
• Press the LOCK switch on the remote con-
trol transmitter.
• Turn the combination headlamps and dip-
per switch to the “ ” or “ ” position.
• Turn the ignition switch to the “ON” posi-
tion or put the operation mode in ON.
 It is possible to modify functions as follows:
NOTE
• The headlamps can be set to come on in the
low beam setting.
• The welcome light function can be deacti-
vated.
For further information, please contact your
authorised MITSUBISHI MOTORS dealer.
Coming home light
NOTE
NOTE
 While the coming home light function is
operating, perform one of the following
operations to cancel the function.
• Pull the turn-signal lever towards you.