Mitsubishi MOTORS 2018 MIRAGE, Owner'S Manual

Page: 138 / 354

Under normal conditions, the ABS warning
lamp comes on when the ignition switch is
turned to the “ON” position or the operation
mode is put in ON and goes off a few sec-
onds later.
CAUTION
l
Any of the following indicates that the ABS
is not functioning and only the standard
brake system is working. (The standard
brake system is functioning normally.) If this
happens, we recommend you to have your
vehicle inspected as soon as possible.
• When the ignition switch is turned to the
“ON” position or the operation mode is
put in ON, the warning lamp does not
come on or it remains on and does not go
off.
• The warning lamp comes on while driv-
ing.
If the warning lamp illuminates
while driving
If only the ABS warning lamp
illuminates
Avoid hard braking and high-speed driving.
Stop the vehicle in a safe place.
Restart the engine and check to see whether
the lamp goes out after a few minutes driv-
ing; if it then remains off during driving,
there is no problem.
However, if the warning lamp do not disap-
pear, or if they come on again when the vehi-
cle is driven, we recommend you to have the
vehicle checked.
If the ABS warning lamp and
brake warning lamp illuminate
at the same time
The ABS and brake force distribution func-
tion may not work, so hard braking could
make the vehicle unstable.
Avoid hard braking and high-speed driving.
Stop the vehicle in a safe place and we rec-
ommend you to have it checked.
After driving on icy roads
After driving on snow or icy roads, remove
any snow and ice which may have accumula-
ted around the wheels. On vehicles that have
an ABS, be careful not to damage the wheel
speed sensors (A) or the cables located at
each wheel.
Front Rear
Anti-lock brake system (ABS)
6-36
OA0X19E2
Starting and driving
6