Mitsubishi MOTORS 2018 MIRAGE, Owner'S Manual

Page: 238 / 354

NOTE
l
When injecting the sealant, position the
valve away from the bottom, i.e., away from
the point where the tyre touches the ground.
If the valve is near the point where the tyre
touches the ground, the sealant may not go
into the tyre easily.
12. After injecting the sealant, pull the hose
off the valve, remove any residual seal-
ant from the valve, rim and/or tyre.
Fit the valve insert (F) into the valve
(D), and screw the valve insert securely
into place using the valve remover (E).
NOTE
l When removing and screwing in the valve
insert using the valve remover, turn the
valve remover by hand. Using a tool to turn
the valve remover could damage it.
13. Insert the plug (K) or the valve remover
(E) in the tip of the filler hose to prevent
the sealant from leaking from the empty
sealant bottle.
14. Pull out the compressor hose (L) from
the side of the tyre compressor, and then
securely attach the hose to the tyre valve
(D).
15. Place the compressor (M) with its air
pressure gauge (N) on top.
Pull out the compressor’s power cord
(O), insert the plug on the cord into the
accessory socket (P), and then turn the
ignition switch to the “ACC” position or
put the operation mode in ACC. (Refer
to “Accessory socket” on page 7-71.)
Turn ON the compressor switch (Q) and
inflate the tyre to the specified pressure.
(Refer to “Tyre inflation pressures” on
page 10-10.)
CAUTION
l The supplied compressor is designed only
for inflation of your vehicle tyres.
Tyre repair kit*
8-10
OA0X19E2
For emergencies
8