Mitsubishi Heavy Industries FDCW60VNX-W, Installation Manual

Page: 61 / 92

59
Control
Menu 5.2 - system settings
0DNHGL൵HUHQWV\VWHPVHWWLQJVIRU\RXULQVWDOODWLRQKHUHHJ
activate the connected heat pump and which accessories are
installed.
Menu 5.2.2 - installed heat pump
If a heat pump is connected to the master installation, set it
here.
For RC-HY40, you can set slave unit to be connected.
There are two ways of activating connected slaves. You can
either mark the alternative in the list or use the automatic
function "search installed slaves".
search installed slaves
Mark “search installed slaves" and press the OK button to
DXWRPDWLFDOO\¿QGFRQQHFWHGVODYHVIRUWKHPDVWHUKHDWSXPS
Menu 5.2.3 – docking (RC-HY 40 only)
Enter how your system is docked regarding pipes, for example
to hot water heating and heating the building.
This menu has a docking memory which means that the control
system remembers how a particular reversing valve is docked
and automatically enters the correct docking the next time you
use the same reversing valve.
s2 slave 1
docking 5.2.3
s3 s4 s5 s6 s7 s8
Marking frame Compressor
Workspace for docking Slave (heat pump)
Slave:
Here you select for which heat pump the docking
setting is to be made.
Compressor:
Select if the compressor in the heat pump is
blocked (factory setting), or standard (docked for example to
pool heating, hot water charging and heating the building).
Marking frame:
Move around the marking frame using the
control knob. Use the OK button to select what you want to
FKDQJHDQGWRFRQ¿UPVHWWLQJLQWKHRSWLRQVER[WKDWDSSHDUVWR
the right.
Workspace for docking:
The system docking is drawn
here.
Factory setting dT at DOT: 10.0
Setting range DOT: -40.0 – 20.0 °C
Factory setting DOT: -20.0 °C
Select the type of heating distribution system.
G7DW'27LVWKHGL൵HUHQFHLQGHJUHHVEHWZHHQÀRZDQGUHWXUQ
temperatures at dimensioned outdoor temperature.
Menu 5.1.22 - heat pump testing
NOTE
This menu is intended for testing heat pump according to
different standards.
Use of this menu for other reasons may result in your
installation not functioning as intended.
This menu contains several sub-menus, one for each standard.
Menu 5.1.23 - compressor curve
Set whether the compressor in the heat pump should work to a
particular curve under specific requirements or if it should
ZRUNWRSUHGH¿QHGFXUYHV
You can set a curve for each operation mode (heat, hot water,
coolingetc.) by unticking "auto", turning the control knob until
a temperature is marked and pressing OK. You can set at what
temperature max- min frequencies will occur.
This menu consists of several windows (one for each operation
mode). Use the navigation arrow in the top left corner to
change between the windows.