190
(2) Initial data setting completed flag
After writing parameter data to the remote buffer memory using the REMTO instruction, turn on Initial data setting
request flag (RY9).
Upon completion of the change of operating conditions, Initial data setting completed flag (RX9) turns on.
For the buffer memory areas that require Initial data setting request flag (RY9) to be turned on and off to enable
the written parameter data, refer to the following:
(
*1
For data link to be made at the power-on of the module power supply
*2
When turning on and off Initial data setting request flag (RY9), check that Remote READY (RXB) turns on before starting
the control.
(a) Device number
The device number of this input signal is as follows:
Signal name
Main A/D converter module
Extension A/D converter module
Initial data setting completed flag
RX9
Initial data setting completion
flag (RX9)
(Setting value A)
(Setting value B)
Module power supply
*1
Starts operation with
the setting value A
Reads settings from
the non-volatile memory
Setting value change
by user
CH A/D conversion completed
flag
(RX10 to RX13, RX20 to RX23)
Controlled by the A/D converter module
Controlled by the program
Initial data setting request
flag (RY9)
Remote READY (RXB)
*2
Parameter area
ON
ON
ON
ON
ON
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
Summary of Contents for NZ2EX2B-60AD4
