1 SERVO PARAMETER DETAILS
1.4 Extension setting servo parameters group ([Pr. PC_ _ ])
65
1
[Pr. PC06_Function selection C-3 (*COP3)]
[Pr. PC06.3_Excessive error alarm trigger level/excessive error warning trigger level -
Unit selection]
Select the unit used when setting the excessive error alarm trigger level in [Pr. PC01 Excessive error alarm trigger level] and
setting the excessive error warning trigger level in [Pr. PC38 Excessive error warning trigger level].
This servo parameter is enabled only in the position control mode.
0: [rev] or [mm]
1: [0.1 rev] or [0.1 mm]
2: [0.01 rev] or [0.01 mm]
3: [0.001 rev] or [0.001 mm]
[Pr. PC07_Zero speed (ZSP)]
Set an output range of the zero speed signal (ZSP).
The zero speed signal detection has a hysteresis of 20 [r/min] (20 [mm/s]).
[Pr. PC08_Overspeed alarm detection level (OSL)]
Set an overspeed alarm detection level.
When a value exceeding "servo motor maximum speed × 120 %" is set, the value will be clamped at "servo motor maximum
speed × 120 %".
When "0" is set, the value of "servo motor maximum speed × 120 %" will be set.
When HK series servo motor is connected, the value of "servo motor maximum speed × 105 %" will be set.
Initial value
Setting range
Setting method
Ver.
00000000h
Refer to the relevant detail No.
Each axis
Refer to the relevant detail No.
Initial value
Setting range
Ver.
0h
Refer to the text
C4
Initial value
Setting range
Setting method
Ver.
50 [r/min], [mm/s]
0 to 10000
Each axis
C4
Initial value
Setting range
Setting method
Ver.
0 [r/min], [mm/s]
0 to 20000
Each axis
C4
Summary of Contents for MR-J5-B
Page 2: ......
Page 153: ...4 SERVO PARAMETER SETTING METHOD 4 2 Controller 151 4 MEMO ...
Page 157: ......