Mitsubishi Electric MELDAS 600M Series, Instruction Manual

Page: 65 / 512

CHAPTER 1 SCREEN OPERATIONS
2. Monitor (Operation) Screens
I
– 50
(3) Notes when executing operation search
Device and program No. settings
1) Always set the O, N or B No. If none of the numbers are set, a setting error occurs.
2) If one or two of O, N and B Nos. are set, the other numbers not set are ignored during the
search.
3) Use the and keys to scroll through the list.
4) When operating with the RS-232C, the settings of parameters related to the data input/
output and the settings of the operation device must match. Refer to "3.5.4 Input/Output
Parameter screen" for details on each data input/output parameter.
5) Use a recommended IC card that matches the Mitsubishi quality standards. Refer to section
"3.3 Data Input/Output screen" for details.
Program after searching
1) If the following operations are carried out on the edit screen after operation search, the state
changes to that in which nothing is searched, and operation is not possible. Research in this
case.
•
When the searched program is erased
•
When the searched sequence No. is erased
•
When the block corresponding to the searched block No. is erased
2) Even when the block is stopped, operation search cannot be carried out with another mode
during MDI multiple block operation. Start the search after MDI operation is completed, or
after the NC is reset.
2.4.2 Executing verify stop
(1) To register the verify stop
1)
The selected device name and directory path appear in
the setting column.
2)
The set numbers appear in the setting column.
D irectory /PR OG RAM
D ev ice HD
N
B
1001
O
(Note)
If the list contents differ from the actual directory, press the
List update
menu.
Set the program device and
directory for executing verify
stop.
Set the program No., and
press the
INPUT
key.
Set the sequence No. and
block No. in N and B
respectively.
When carrying out a verify stop
of the MDI, set "0" for the
program No.
Downloaded from ManualsNet.com search engine