Mitsubishi Electric FX5-DP-M, User Manual

Page: 22 / 176

20
2 SPECIFICATIONS
2.4 Part Names
2.4
Part Names
Shows the name of each section of the FX5-DP-M.
LED display
*1 Flashes when the module requests or responds to the Acyclic communication.
No. Name Description
[1] PROFIBUS-DP interface connector This connector connects a cable for PROFIBUS-DP network. (9-pin D-Sub connector: #4-40 UNC inch screw)
[2] Extension cable Cable for connecting the module when adding the FX5-DP-M.
[3] Direct mounting hole Screw holes (2- φ 4.5, mounting screw: M4 screw) for direct installation
[4] Operation status display LEDs Indicates the operating status of the module. (

Page 20 Transmission distance)
[5] Extension connector Connector for connecting the extension cable of an extension module.
[6] Name plate The product model name and manufacturer's serial number are shown.
[7] DIN rail mounting groove The module can be installed on DIN46277 rail (35 mm wide).
[8] DIN rail mounting hook Hook for mounting the module on a DIN rail of DIN46277 (35 mm wide).
[9] Pullout tab They are used when drawing out an extension cable.
LED name LED color Description
SD/RD Green Indicates the communication status with DP-Slaves.
On or flashing: During data exchange, or Acyclic communication.
*1
Off: During data exchange stop.
DIA Red Indicates the diagnostic information and the alarm detected.
On: Diagnostic information or alarm is detected.
Off: No diagnostic information and no alarm.
BF Red Indicates the occurrence of a communication error.
On: Diagnostic information is detected.
Off: No diagnostic information.
POWER Green Indicates the power supply status.
On: Power on
Off: Power off or module failure
RUN Green Indicates the operating status.
On: Normal operation
Off: Error
ERROR Red Indicates the error status.
On: Minor error or major error
Flashing: Moderate error or major error
Off: Normal operation
[1]
[9]
[2]
[3]
[7]
[6]
[8]
[4]
[5]
2-

4.5 Mounting holes