Mitsubishi Electric F720PJ-11KF, Manual

Page: 48 / 96

48
When setting parameters, refer to the instruction manual (applied) and understand instructions.
 You can use the setting dial of the operation panel like a
potentiometer to perform operation.
 The key operation of the operation panel can be disabled.

When setting a frequency using the setting dial on the operation
panel, the frequency change increment is determined by how
quickly the setting dial is rotated.
Use these parameters to select/change the input terminal
functions.

When Pr. 59 Remote function selection

"0", the functions of the RL, RM
and RH signals are changed as given in the table.

The OH signal turns ON when the relay contact "opens".
161, 295
Operation selection of the operation
panel
Pr.161 Frequency setting/key lock operation selection
Pr.295 Magnitude of frequency change setting
Pr.161
setting
Description
0
(initial value)
Setting dial frequency setting mode
Key lock mode in valid
1 Setting dial potentiometer mode
10 Setting dial frequency setting mode
Key lock mode valid
11 Setting dial potentiometer mode
162, 165 Refer to the section about Pr.57
166 ,167
Refer to the section about Pr.150
168, 169
Parameter for manufacturer setting. Do not set.
170, 171
Refer to the section about Pr.52
178 to 182
Function assignment of input terminal
Pr.178 STF terminal function selection Pr.179 STR terminal function selection
Pr.180 AU terminal function selection Pr.181 RM terminal function selection
Pr.182 RH terminal function selection
Pr.178 to
Pr.182
setting
Signal
Name
Function
0 RL
Pr.59
=0 (initial value)
Low-speed operation
command
Pr.59

0

Remote setting (setting
clear)
1 RM
Pr.59 =0 (initial value)
Middle-speed operation
command
Pr.59

0

Remote setting
(deceleration)
2 RH
Pr.59
=0 (initial value)
High-speed operation
command
Pr.59

0

Remote setting
(acceleration)
3 RT Second function selection
4 AU Terminal 4 input selection
5 JOG Jog operation selection
7 OH External thermal relay input

8 REX
15-speed selection (combination with three
speeds RL, RM, RH)
10 X10
Inverter run enable signal (FR-HC2, FR-CV
connection)
12 X12 PU operation external interlock
14 X14 PID control valid terminal
16 X16
PU/External operation switchover (turning ON
X16 selects External operation)
24 MRS Output stop
25 STOP Start self-holding selection
60 STF
Forward rotation command (assigned to STF
terminal
(Pr. 178) only)
61 STR
Reverse rotation command (assigned to STR
terminal
(Pr. 179) only)
62 RES Inverter reset
64 X64 Starting frequency for elevator mode
65 X65 PU/NET operation switchover
66 X66 External/NET operation switchover
67 X67 Command source switchover
72 X72 PWM frequency selection
9999

No function